Pptp Encapsulation - ZyXEL Communications NBG-416N User Manual

Chapter 8 WAN
The following table describes the labels in this screen.
Table 34 Network > WAN > Internet Connection: PPPoE Encapsulation
LABEL
ISP Parameters for Internet Access
Connection
Type
Service Name
User Name
Password
Retype to
Confirm
MTU Size
Nailed-Up
Connection
Idle Timeout
DNS Servers
First DNS
Server
Second DNS
Server
WAN MAC
Address
Factory default
Clone the
computer's
MAC address -
IP Address
Set WAN MAC
Address
Apply
Reset

8.3.3 PPTP Encapsulation

Point-to-Point Tunneling Protocol (PPTP) is a network protocol that enables secure
transfer of data from a remote client to a private server, creating a Virtual Private
Network (VPN) using TCP/IP-based networks.
88
DESCRIPTION
Select PPP over Ethernet if you connect to your Internet via dial-up.
Type the PPPoE service name provided to you. PPPoE uses a service
name to identify and reach the PPPoE server.
Type the user name given to you by your ISP.
Type the password associated with the user name above.
Type your password again to make sure that you have entered is
correctly.
Enter the MTU or the largest packet size per frame that your NBG-416N
can receive and process.
Select Nailed-Up Connection if you do not want the connection to time
out.
This value specifies the time in minutes that elapses before the router
automatically disconnects from the PPPoE server.
Enter the primary and secondary DNS server's IP addresses.
If you do not configure a DNS server, you must know the IP address of a
computer in order to access it.
The MAC address section allows users to configure the WAN port's MAC
address by using the NBG-416N's MAC address, copying the MAC
address from a computer on your LAN or manually entering a MAC
address.
Select Factory default to use the factory assigned default MAC
Address.
Select Clone the computer's MAC address - IP Address and enter
the IP address of the computer on the LAN whose MAC you are cloning.
Once it is successfully configured, the address will be copied to the rom
file. It will not change unless you change the setting or upload a
different ROM file.
Select this option and enter the MAC address you want to use.
Click Apply to save your changes back to the NBG-416N.
Click Reset to begin configuring this screen afresh.
NBG-416N User's Guide