ZyXEL Communications NBG-416N User Manual page 90

Chapter 8 WAN
Table 35 Network > WAN > Internet Connection: PPTP Encapsulation (continued)
LABEL
Password
Retype to Confirm
MTU Size
Nailed-up
Connection
Idle Timeout
PPTP Configuration
Server IP Address/
Domain
Connection ID/
Name
Get automatically
from ISP
Use fixed IP
Address
My WAN IP
Address
My IP Subnet
Mask
My IP Gateway
DNS Servers
First DNS Server
Second DNS Server
WAN MAC Address
Factory default
Clone the
computer's MAC
address - IP
Address
Set WAN MAC
Address
Apply
Reset
90
DESCRIPTION
Type the password associated with the User Name above.
Type your password again to make sure that you have entered
correctly.
Enter the MTU or the largest packet size per frame that your NBG-
416N can receive and process.
Select Nailed-Up Connection if you do not want the connection to
time out.
This value specifies the time in minutes that elapses before the
NBG-416N automatically disconnects from the PPTP server.
Type the IP address of the PPTP server.
Type your identification name for the PPTP server.
Select this option If your ISP did not assign you a fixed IP address.
This is the default selection.
Select this option If the ISP assigned a fixed IP address.
Enter your WAN IP address in this field if you selected Use Fixed IP
Address.
Your NBG-416N will automatically calculate the subnet mask based
on the IP address that you assign. Unless you are implementing
subnetting, use the subnet mask computed by the NBG-416N.
Enter a Gateway IP Address (if your ISP gave you one) in this field.
Enter the primary and secondary DNS server's IP addresses.
If you do not configure a DNS server, you must know the IP address
of a computer in order to access it.
The MAC address section allows users to configure the WAN port's
MAC address by either using the NBG-416N's MAC address, copying
the MAC address from a computer on your LAN or manually entering
a MAC address.
Select Factory default to use the factory assigned default MAC
Address.
Select Clone the computer's MAC address - IP Address and
enter the IP address of the computer on the LAN whose MAC you
are cloning. Once it is successfully configured, the address will be
copied to the rom file. It will not change unless you change the
setting or upload a different ROM file.
Select this option and enter the MAC address you want to use.
Click Apply to save your changes back to the NBG-416N.
Click Reset to begin configuring this screen afresh.
NBG-416N User's Guide