Table of Contents
Advertisement
Additional Information
Wall Mount (Optional)
Notes:
• Check the reception strength and baby unit camera angle before drilling any holes.
• The types of screws and wall plugs you need depend on the composition of the wall. You
may need to purchase the screws and wall plugs separately to mount your baby units.
1� Place the wall mount bracket on a wall and then use a pencil to mark two holes
in parallel. Remove the wall mount bracket and drill two holes in the wall (5.5mm
drill bit).
2� If you drill the holes into a stud, go to step 3.
If you drill the holes into an object other than a stud, insert the wall plugs into
the holes. Tap gently on the ends with a hammer until the wall plugs are flush
with the wall.
40
Advertisement
Table of Contents
