Control Elements And Connections - Fronius TransSynergic 4000 Plasma Operating Instructions Manual

Control elements and connections

Safety
Control elements
and connections
(4)
(3)
(2)
(1)
TS 4000 Plasma front view
No. Function
(1) (-) current socket with bayonet latch
(2) „Power source ON" indicator
(3) Robot interface indicator
(4) Error indicator
(5) Mains switch
(6) (+) current socket with bayonet latch
(7) Earthing connection, M6 thread (on the interface)
(8) Interface
(9) (-) current socket with bayonet latch
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described here until you have read and
completely understood all the operating instructions.
TransSynergic 4000 Plasma
for connecting the power cable
lights up when the power source is plugged into the mains and the mains switch is
in the - I - position
lights up when the power source is switched on, provided that a robot interface or a
field bus coupler is connected to the LocalNet and there is a data connection to the
interface
lights up until the interface is initialised by the external control or if an error occurs
during operation.
for switching the power source on and off
for connecting the power cable
for connecting the power source to the controller
Connections as specified in the interface operating instructions
for connecting the power cable
(5)
(7)
(6)
TS 4000 Plasma with interface, rear view
3
(8) (9)