Panasonic AlCare TK-AS500 Operating Instructions Manual page 30

Alkaline ionizer
Table of Contents

Advertisement

Replacing the Cartridge
Do not tip over the main unit, or face up the main spout.
z
(Water may enter the inside of the main unit, resulting in a malfunction.)
Since the cartridge usage amount needs to be reset, do not remove the power
z
plug when replacing the cartridge.
Before replacing the cartridge, turn off the faucet. Do not run water through the
z
Alkaline Ionizer with the cartridge removed.
(Doing so may cause the water to overflow.)
Dispose of the used cartridge in accordance with the applicable ordinances in the area concerned.
z
(The material of the cartridge cover is ABS. For the type of the filter materials, refer to P. EN43.)
Preparation: Please turn off the faucet.
1
Remove the
cover.
Hook your finger on
the protrusion
Slide
the cover
while
pushing
the
protrusion
2
Remove the old
cartridge.
Push down the top
Pull toward you
Pull up and out
Point the main spout toward
z
the inside the sink. (Water flows.)
Take care since water will drip from the cartridge.
z
( Water may also drip from the bottom of the unit,
but this is not a water leak.)
3
Install the new
cartridge.
Align the cartridge
with the center of the
bottom surface, and
push it in.
Insert the cartridge
firmly.
Push up the cartridge
until it clicks.
EN30
Replacing method
While
pushing the
protrusion with
the finger
Cover
Main spout
(continued)
4
Press approx. 3 seconds.
Unlit
z
Be sure to press
z
earlier than the replacement timing.
(To display the next replacement timing correctly)
5
Open the faucet, and
run alkaline ion water
through the main
unit.
( for about 3
or 4 minutes)
While water is
running through
the main unit, check that water is not leaking from
the area where the cartridge was installed.
When water is run immediately after cartridge
z
replacement, the water quality signal blinks approx.
20 seconds.
6
Turn off the faucet,
and attach the cover to finish
the cartridge replacement.
Place the cover along the rear of the main unit,
and slide it.
Set the protrusions of
the cover into
the grooves
of the
main unit.
Cartridge replacement guideline is
reset.
even when it is replaced
Drain hose
Set the 4
protrusions into
the grooves of
the main unit.
Pi-

Advertisement

Table of Contents
loading

Table of Contents