Table of Contents
Advertisement
Keep all parts that are not used during installation, as they may be needed later if the unit is moved or the faucet
is changed.
Faucet without an aerator
• Water faucet to which the Alkaline
Ionizer can be installed with an
accessory.
1
Remove the nut and adaptor.
2
Insert the installation adaptor,
and tighten it with the nut.
3
Tighten the 4 screws temporarily
and loosen the nut to leave a
3 to 4 mm gap.
4
Push the bypass selector
against the faucet and install the
4 screws as shown below.
Top view
z
<OK> <NG>
5
Tighten the nut until the bypass
selector does not turn.
Do not use any tools.
z
(Doing so may damage the nut.)
Make sure the bypass selector is
z
not inclined.
Bulge
Gasket
Do not remove the gasket and the filter
inside the bypass selector.
If these are removed, return them to the
original position.
Make sure foreign matter is not attached
to the filter and the gasket is not inclined.
Water faucet
2 Installation adaptor
3 Screws
11 mm or more
2 13 mm or more, less than 24 mm
and
Filter
Remove the screws
(4 pcs.)
Installation adaptor
(Accessory)
Nut
3–4 mm
Water faucet
Bypass selector
Nut
Nut
Adaptor
(with gasket)
Gasket
Bypass selector
Nut
Screws
(4 pcs.)
EN17
Advertisement
Chapters
Table of Contents
