Advertisement
The MCS2 has two modes of operation; PLAY mode, in which you will normally use it, and ASSIGN mode,
in which you can assign controllers to send any type of MIDI control message you want. When you turn
the MCS2 on, it will be in PLAY mode.
PLAY
mode
In this mode, moving a controller will send the MIDI message which
has been assigned to it.
The LCD will show the MIDI channel number that the MCS2 is trans-
mitting on and the Program Change number that was last selected.
You can use the Program Change switches 1-8 to send MIDI Program
Program
Change
Change messages 1-64. The Program Changes are in 8 banks of 8.
First select the bank. Press a Program Change switch and the selected
bank number will appear in the left place of the LCD Program display.
The right piace will begin blinking. When you press another Program
Change switch, the display will stop flashing and the selected MIDI
program Change message will be sent.
PROGRAM CHANGE
FS1
PS1
FS2
l
PS2
i
PS3
Laad
Ld
MIDI CH
PROGRAM
MIDI CH
PROGRAM
The LCD will show 11-88, corresponding to Program Changes 1-64.
BANK TI BANK 2/BANK 3|BANK 4|BANK 5
ON
Da
E GM
—
Advertisement
