Advertisement
FRONT PANEL
REAR PANEL
The MCS2 has 3 fixed controllers who's function cannot be changed
@
Pitch Bend
@ > Modulation
@)
Breath controller jack (Use Yamaha BS1 Breath Controller)
and 9 assignable controllers which you can assign to send any type of
MIDI control message.
@
Continuous Slider 1 and 2 (CS1, CS2)
@
Push Switch 1, 2 and 3 (PS1, PS2, PS3)
©
Foot Controller jack 1 and 2 (FC1, FC2)
(Use Yamaha FC7 Foot Controller)
@
Foot Switch jack 1 and 2 (FS1, FS2)
(Use Yamaha FC4/FC5 Foot Switch)
Program Change
The MCS2 has 8 Program Change switches. Pressing these will send
MIDI Program Change messages 1-64 (8 banks of 8 = 64).
@
Bank Hold
Press this switch to enter Bank Hold mode, where you can select
programs in groups of 8. Pressing and holding this switch will take you
to ASSIGN mode.
LCD
A 5-character Liquid Crystal Display, backlit for high visibility. In PLAY
mode it displays the MIDI channel and the most recently sent program
change. In ASSIGN mode it alternately displays the controller and its
assignment.
@
MIDIIN 1,2
The MCS2 has two MIDI inputs. Messages received here are merged
(mixed) with the MIDI messages generated by the MCS2 itself and
sent from MIDI OUT. To avoid conflicting signals (such as two differ-
ent Timing Clocks), MIDI IN 2 will accept only Channel Messages, ie.
all) System Messages are filtered out. (MIDI IN 2 will, however, accept
Active Clock messages $FE.)
q@
MIDI OUT
The messages from MIDI IN 1 and 2 are combined with the messages
from the MCS2 itself, and sent from this jack.
@
DC9V-12V IN
Use the AC adaptor included with the MCS2.
POWER SWITCH
When you turn the MCS2 on, it will be in PLAY mode.
Advertisement
