Advertisement
Select the controller
Assign the controller
Try it out
We read that the pf80 recognizes Control Changes 1 and 4 as tremolo
depth and speed. So, we want to assign the controller as shown in the
Controller Assign Table below. (The pf80 MIDI Implementation Chart
also tells us that for these messages to be recognized, the pf80 switch
F1 or F2 must be on.)
CS1 = Control Change 1 (Tremolo depth)
CS2=Control
Change 4 (Tremolo speed)
Move CS1
until the LCD shows "CS1=".
As long as you are moving
CS1, the LCD will show the selected
controller, but once you stop moving it, the LCD will begin to alternate
between showing the controller and its current assignment
(in the
initial setting, PREO3).
FS1
—
PS1
2
Yd PCEQIEE
MIDI CH
PROGRAM
Move CS2 (or press
) until the LCD shows "CC001".
As we explained above, once
you stop moving it, the LCD will begin
to alternate between showing
the controller and its current assigment.
Easy, wasn't it? You have just assigned CS1 to send Control Change 1.
In the same way, assign CS2 to Control Change 4. Move CS1 to select
"CS2="
and assign it to "CC004".
To try it out, go back to PLAY mode by pressing
[BANK HOLD].
(Controllers will not send messages while in ASSIGN
mode.)
Make
sure the pf80 switch F1 or F2 is on, and change the tremolo depth and
speed by moving CS1 and CS2. Moving the Pitch Bend wheel will also
affect the pf80.
E C a
Advertisement
