Advertisement
ASSIGN
mode
MIDI CHANNEL
To enter ASSIGN mode, press and hold the
switch for
about one second. The LCD will show "ASSIG."
In ASSIGN
mode,
moving a controller will not send any MIDI messages, as you see from
the block diagram on p.6.
ASSIGN
FS1
ps1
FS2
A
if
Lese
HOLD
(Lu
CES
E
C
SEE
MIDI CH
PROGRAM
ASSIGN
mode is where you assign the controllers to send whatever
MIDI control message you like. Use the CS1 slider to select the con-
troller you want to assign, and use the CS2 slider and / or
/
switches to select the assignment for that controller.
As you move CS1, the LCD will show the various controllers.
DISPLAY
CONTROLLER
Foot Switch 2
Foot Switch 1
Push Switch 3
Push Switch 2
Push Switch 1
Continuous Slider 2
Continuous Slider 1
csi
Foot Controller 2
Foot Controller 1
MIDI Channel
CONTROLLER
III
NOTE:
When shipped, the MCS2 controllers will be assigned as shown
on p.24. You can set the MCS2 memory to this condition by using
the INITIALIZATION function explained on p.24.
You can select the MIDI channel on which the MCS2 will send ail its
messages. The selected channel
number will be displayed in PLAY
mode (see p.7). Move CS2 to select MIDI channels 1-16. Be sure that
the receiving device is either receiving this channel or is set to OMNI
ON.
Advertisement
