Kraus Bolden KFF-1610 Installation Manual page 8

Step 5: Flushing and checking for leaks
1
A
Keep inward
Fig 1
8
Cold
Hot
Open
OFF
ON
Fig 2
Unfiltered Water Function
Pull the hose assembly out of the spout and
remove the spray head (A) by unscrewing it from
the hose in a counterclockwise direction. Be sure
to hold the end of the hose down into the sink
and turn the faucet to the warm position where it
mixes hot and cold water. Pulling the handle
towards yourself will turn the water to hot.
Pushing the handle away from yourself will turn
the water to cold. Flush the water lines for one
minute. This flushes away any debris that could
cause damage to internal parts. Check for leaks.
Retighten any connections if necessary, but do
not overtighten. Reinstall the spray head (A) by
hand tightening it back onto the spray
hose in a clockwise direction.
NOTE: Please make sure the washer (1) is
installed before attaching the spray head to the
hose.
Filtered Cold Water Function
Make sure the the faucet is closed and do not
open the handle outward, as shown in the Fig 1.
Maintain the state of the Fig 1, pulling the handle
towards yourself will activate the filtered water, as
shown in the Fig 2.
Flush the water lines for one minute. This flushes
away any debris that could cause damage to
internal parts. Check for leaks.
Maintain the state of the Fig 1, pushing the
handle away from yourself will turn off the filtered
water, as shown in the Fig 2.