Using Your Induction Hob; To Start Cooking; When You Have Finished Cooking - Candy CIS633DTT/1 Instruction Manual

The base diameter of induction cookware
Cooking zone Minimum (mm)
1,2(180mm) 120
3 (280mm) 180
The above may vary according to the quality of the pan used.

Using your Induction Hob

To start cooking

1. Touch the ON/OFF control.
After power on, the buzzer beeps once, all displays show
" – " or " – – ", indicating that the induction hob has entered
the state of standby mode.
2. Place a suitable pan on the cooking zone that
you wish to use.
• Make sure the bottom of the pan and the surface
of the cooking zone are clean and dry.
3.Select one heating zone and set a power level by touching the "-" or "+"
control.
a. If you don't set the power within 1 minute, the induction hob will
automatically switch off. You will need to start again at step 1.
b. You can modify the heat setting at any time during cooking.
If the display flashes
setting
This means that:
• you have not placed a pan on the correct cooking zone or,
alternately with the heat
EN-11
• the pan you're using is not suitable for induction cooking or,
• the pan is too small or not properly centred on the cooking zone.
No heating takes place unless there is a suitable pan on the cooking zone.
The display will automatically turn off after 1 minutes if no suitable pan is placed
on it.

When you have finished cooking

1. Turn the cooking zone off by touching the "-" control that you
wish to switch off.
Make sure the power display shows "0", then shows "H".
and then
2.
Turn the whole cooktop off by touching the ON/OFF control.
3. Beware of hot surfaces
'H' will show which cooking zone is hot to touch. It will disappear when the
surface has cooled down to a safe temperature. It can also be used as an
energy saving function if you want to heat further pans, use the hotplate that
is still hot.
Using the Power Management
Using power management you can set the total power to 2.5kW/ 3.0kW/ 4.5kW/
5.5kW and 6.9kW. The default total power setting is the maximum power level.
Setting the total power level to fit your requirement
1. Make sure the cooktop is turned off.
Note: you can only set power management when the cooktop is turned off.
2.Touch the button "Stop + Go" and hold for 5 seconds. You can hear
EN-12