Table of Contents
Advertisement
Customizing DSX-1-Compatible Units
Making Changes from the Terminal Interface
4-2
The Board Configuration menu displays the current board software and hardware
settings. It also allows you to change certain parameters on the board.
This function is affected by the status of the switchpack (DIP switch control)
setting.
When operating in Terminal Mode (the system default) you can make
configuration changes through the terminal menus.
When operating in Switchpack Mode, you can display configuration
parameters using the terminal menus, but any configuration changes must be
made using the switches on the circuit board. Refer to
Switchpack Mode
on page 4-4.
To access the Board Configuration menu, enter 3 at the Main Menu Command
prompt.
The following example shows the menu that appears for a CP unit.
Command
3
Board Configuration:
–––––––––––––––––––
1) SDSL Card Type
SDSL Rate Type
2) T1 Line Encode
3) Framing
4) Line Build Out
SDSL FW Rev
Globespan FW Rev
CP Serial #
–––––––––––––––––––––––––––––––––––––––––––––––––––––––
1–4)
Board Configuration
5)
Switchpack Definitions
?)
Prints Board Configuration and this menu
Q)
Quit
Config
The Switchpack Definitions screen, option 5 on the Config menu, displays the
switchpack settings to use when changing configuration changes manually. Refer
Displaying Switchpack Definitions
to
Possible values for each option are listed in
NOTE:
See Appendix A,
Worksheets ,
configuration options for your application.
February 1998
– CP
– T1
– B8ZS
– D4
– 0 to 133 feet, 0dB
– 1.0
– 1.12
– 088165
on page 4-5.
Table
4-1.
for help in selecting the appropriate
Making Changes in
7914-A2-GB20-00
Advertisement
Table of Contents
