Table of Contents
Advertisement
Figure 38. Installing the Contour Rigging System on
CT28
• Using a 3 mm hex key (Allen type) with a length that allows
for sufficient leverage, tighten the screws into the inserts in
opposing pairs to firmly attach the Rigging System to the CT28.
The bottom surface of the Rigging System should be perfectly
flush with the cabinet at every point and there should be no
movement possible.
Installing the Tube Mount on the Contour Rigging System
Once the suspension yoke has been removed, the Contour CT28 Rigging
System can be coupled to the Tube Mount adaptor. This procedure
can be carried out either before or after the Rigging System has been
installed on the CT28.
Figure 39. Inserting the bolt.
| 4 - DEPLOYING CT28 ATOP SUB215
• Place the Tube Mount with the drilled-plate end onto the sliding
block of the Contour Rigging System, aligning the hole in the
Tube Mount with the threaded ½" hole in the sliding block.
• Pass the ½" bolt through the split locking washer and thread the
bolt (both included with the Tube Mount) into the tapped hole in
the sliding block, through the hole in the Tube Mount.
Figure 40. Tightening the lug bolt.
• Use a ¾" (19 mm) socket wrench with a socket extension at
least 8 cm long to firmly tighten the lug bolt into the sliding block.
Fixing Tilt Angle of the Contour Rigging System
The Contour Rigging System allows for a variable tilt angle from +20°
to -20° in 5° increments. It is convenient to fix the tilt angle before
mounting the CT28 atop an Active Speaker Tube, though the angle can
be subsequently adjusted if necessary.
Figure 41. The tilt-locking holes and their
corresponding
angles
configuration.
in
the
pole-mount
Advertisement
Table of Contents
