Table of Contents
Advertisement
Chapter 4. Deploying CT28 atop
SUB215
Critical information
Attention: This equipment is intended for installation by qualified
professionals.
Notice: Please read these instructions carefully and completely
before attempting deployment of speaker enclosures on floor
stands.
Tipping Hazard
Speaker enclosures stacked atop one another, even
when properly coupled, represent a tipping hazard.
Exercise extreme care when assembling speaker
arrays, as a stack of them toppling or collapsing
creates a risk of serious injury or death, as well as likely
damage to the enclosures themselves and nearby
equipment.
Notice: This product must be installed in compliance with all
applicable local, state and national regulatory provisions. The
responsibility rests with the installer to verify that the installation
is carried out in accordance with any applicable legislation.
Important: The installer must assess the appropriate stability
and sturdiness of the deployment surface.
Restriction: Only hardware and accessories included with
the product or specified by 1 Sound should be used for its
installation.
Restriction: Do not modify or alter the loudspeaker or any
accessory. Any modification by the user or installer could render
the product or the installation unsafe.
Restriction: Do not install a loudspeaker or any accessory near
any open flame or heat source.
Products, accessories and tools required
To deploy a Contour CT28 enclosure on an Active Speaker Tube with
Base you will need the following:
•
A
CT28 (on page 3)
•
The
Countour CT28 Rigging System (on page 4)
•
The 95 cm
Active Speaker Tube (on page 5)
Passive Speaker Tube (on page 4)
•
A
SUB215 (on page 3)
•
The
Tube Mount (on page 4)
•
A 3 mm hex driver or Allen wrench
•
A 4 mm hex driver or Allen wrench
•
A 5 mm hex driver or Allen wrench
•
A ¾" (19 mm) socket driver with at least an 80 mm shaft
•
Thread-locking compound
Procedures
Removing the Suspension Yoke from the Contour Rigging
System
Before the Contour CT28 Rigging System can be equipped with the Tube
Mount adaptor, the suspension yoke must be removed.
Note: The Yoke can be installed on or removed from the Contour
Rigging System while either before or after the Rigging System
is installed on the CT28.
WARNING
loudspeaker enclosure
subwoofer enclosure
adapter kit
or the
40 cm
Advertisement
Table of Contents
