Installing The Contour Rigging System On The Ct28 Bottom - 1 Sound Contour Series Manual

Figure 32. Removing the M8 x 20 mm bolts to
remove the suspension yoke.
• Use a 5 mm hex wrench to loosen the two M8 x 20 mm button-
head bolts on either side of the suspension yoke.
Figure 33. Removing the suspension yoke.
| 4 - DEPLOYING CT28 ATOP SUB215
• Once these two bolts have been removed, the yoke can simply
be lifted off of the Contour Rigging System.

Installing the Contour Rigging System on the CT28 bottom

In order to mount the CT28 unit on a subwoofer or pole mount and to
allow for variable tilt angles of the enclosure in sub/satellite configurations
using the Tube mount and Active Speaker Tube, the speaker enclosure
needs to be equipped with the Contour Rigging System.
If the CT28 unit is not pre-equipped with the Contour Rigging System,
this can be mounted by the user.
Attention: For the installation of the Contour Rigging System
on the CT28 or CT212 enclosure, the use of medium-strength
thread-locking compound is REQUIRED on all user-installed
screws.
Figure 34. Threaded inserts for the Contour Rigging
System on the bottom of CT28.