Table of Contents
Advertisement
Figure 23. Sliding the mounting block to fix the tilt
angle.
Figure 24. Sliding the tilt mechanism to align the
required tilt angle (+20° upward tilt in the pole-
mount configuration shown).
• With the M10×100 ball-lock pin removed, slide the mounting
block of the tilt mechanism to align the holes in the block with
the holes in the arched plates corresponding to the required tilt
angle (see diagrams above).
Figure 25. Inserting the ball-lock pin to fix the
tilt angle (+20° tilt in the pole-mount configuration
shown).
| 3 - DEPLOYING CT28 ON AN ACTIVE SPEAKER TUBE AND BASE
• When the required holes are perfectly aligned, take the other
M10×100 ball-lock pin supplied with the Contour Rigging
System and press the lock-release button on the rear of the pin
to allow it to pass into the hole. Insert it into the holes, pushing it
completely through the aligned holes until the ball-lock emerges
from the far side.
Figure 26. A +20° tilt angle fixed for the pole-mount
configuration.
• When it emerges, release the button to allow the lock to engage
and assure that the pin cannot be removed without again
pressing the release. The enclosure is now ready to mount on
an Active Speaker Tube.
Mounting CT28 on Active Speaker Tube
Once the Contour CT28 Rigging System has been correctly assembled
with the Tube Mount, coupled with a CT28 and the tilt angle has
been fixed, the enclosure can then be very simply mounted on an
Active Speaker Tube, either atop a SUB215 subwoofer in a sub/satellite
configuration, or independently atop an Active Speaker Tube with base.
Tipping Hazard
Improper assembly of the Active Speaker Tube with
Base or improper installation of the Active Speaker
Tube or Sub Pole Cup on the SUB215 subwoofer
enclosure, or of the Tube Mount, Contour Rigging
System and CT28 enclosure could create a hazardous
or unstable condition.
Follow all specific instructions for the assembly of
each of these products and verify their stable and
level condition before attempting to mount a speaker
enclosure atop the Subwoofer or the Active Speaker
Tube and Base. DO NOT ATTEMPT TO MOVE OR
REPOSITION A SUB/SATELLLITE ASSEMBLY OR
A FREE-STANDING SPEAKER STAND WITH AN
ENCLOSURE MOUNTED ATOP IT.
TIPPING HAZARD
DO NOT USE THE 145 cm ACTIVE SPEAKER
TUBE TO MOUNT A CT28 UNIT ATOP THE SUB215
SUBWOOFER
TO
REDUCE
DAMAGE THAT COULD RESULT FROM POSSIBLE
TOPPLING OF LOUDSPEAKER ENCLOSURES,
ONLY THE 95 cm ACTIVE SPEAKER TUBE OR THE
40 cm SPEAKER TUBE TO MOUNT ENCLOSURES
IN SUB/SATELLITE CONFIGURATIONS ATOP THE
SUB215 SUBWOOFER.
WARNING
WARNING
THE
RISK
OF
INJURY
OR
Advertisement
Table of Contents
