Procedures; Assembling Active Speaker Tube With Base; Removing The Suspension Yoke From The Contour Rigging System - 1 Sound Contour Series Manual

Procedures

Assembling Active Speaker Tube with Base

The 175 cm Active Speaker Tube and base can be used to deploy a
single, freestanding LCC44 unit. The stand and base must be properly
assembled prior to coupling with the speaker enclosure.
Figure 9. The Active Speaker Tube base.
• Place the round base of the Active Speaker Tube on a flat
surface so that it rests flat and the M20 threaded nut at the
center protrudes above.
Figure 10. Attaching the 175 cm Active Speaker
Tube to its base.
• Align and thread the M20 threaded rod at the bottom of the 175
cm Active speaker Tube into the captive M20 nut on the base .
Figure 11. Screwing the 175 cm Active Speaker tube
to its base.
• Screw the Active Speaker Tube into the base until the outer ring
of the Speaker tube is firmly seated against the base. Check to
see that there is no movement possible of the Speaker Tube
with respect to the base plate.
| 3 - DEPLOYING CT28 ON AN ACTIVE SPEAKER TUBE AND BASE
Figure 12. The fully Assembled Active Speaker
Tube and Base
•
Removing the Suspension Yoke from the Contour Rigging
System
Before the Contour CT28 Rigging System can be equipped with the Tube
Mount adaptor, the suspension yoke must be removed.
Note: The Yoke can be installed on or removed from the Contour
Rigging System while either before or after the Rigging System
is installed on the CT28.