Fixing The Tilt Angle Before Flying The Ct28 - 1 Sound Contour Series Manual

Figure 64. Installing Contour Rigging System on
CT28
• Using a 3 mm hex key (Allen type) with a length that allows
for sufficient leverage, tighten the screws into the inserts in
opposing pairs to firmly attach the Rigging System to the CT28.
The bottom surface of the Rigging System should be perfectly
flush with the cabinet at every point and there should be no
movement possible.

Fixing the tilt angle before flying the CT28

The Contour Rigging System allows for a variable tilt angle from +20° to
-20° in 5° increments. It is convenient to fix the tilt angle before mounting
the CT28 atop an Active Speaker Tube or before flying the enclosure
from a truss or batten, though the angle can be subsequently adjusted
if necessary.
Figure 65. The tilt-locking holes and their
corresponding angles
configuration.
in the suspended
| 5 - FLYING CT28 FROM A TRUSS OR BATTEN
Figure 66. Sliding the mounting block to fix the tilt
angle.
Figure 67. Sliding the tilt mechanism to align the
required tilt angle (-20° downward tilt in the flown
configuration shown).
• With the M10×100 ball-lock pin removed, slide the mounting
block of the tilt mechanism to align the holes in the block with
the holes in the arched plates corresponding to the required tilt
angle (see diagrams above).