Table of Contents
Advertisement
Chapter 5. Flying CT28 from a
truss or batten
Critical information
Notice:
This product must be installed in compliance with all applicable
local, state and national regulatory provisions. The responsibility
rests with the installer to verify that the installation is carried out
in accordance with any applicable legislation.
Important:
Read these instructions in their entirety before deploying,
operating or servicing the system. Conserve this manual for
future reference.
CAUTION
Flown deployment of this system should only be
carried out by professionals who, where required, are
appropriately certified according to local or national
norms and have received specific training relative to
this system. All local and national norms, regulations
and guidelines must be followed during the installation
and removal procedures and for the entire duration
of an installation of this system, including the use of
proper protective clothing and gear.
Notice:
Use only original 1 Sound components and rigging accessories.
Notice: 1 Sound cannot be held responsible for any rigging
equipment and accessories that are not manufactured or directly
provided by 1 Sound. It is the responsibility of the installer to
verify that the rated and certified Working Load Limit (including
required Factor of Safety) of all additional rigging equipment
is greater than the total weight of the entire system including
cables and accessories. This includes all hoists, winches, lifters,
elevators, towers, ground-supports, trussing, chains, safety
cables, clamps, webbing and any other component used in a
flown deployment of this system.
Attention:
It is the responsibility of the installer to verify that the Working
Load Limit (WLL) of the suspension points is greater than
the total weight of the entire system including cables and
accessories.
Important:
Inspect the system before any deployment. If a rigging accessory
or any part of it is missing or not solidly secured, or if any
part of the loudspeaker or accessory exhibits bending, cracks,
deformation, wear or corrosion, do not use the product before
performing corrective maintenance.
DANGER
Risk of Falling Objects
Ensure that it is impossible for any person to remain
or pass beneath the loudspeaker system during the
rigging and lifting process. The system should never
be left unattended during the rigging process. 1 Sound
recommends the use of safety slings at all times.
Advertisement
Table of Contents
