Table of Contents
Advertisement
Repair
Install FCM Upgrade Token
Install Upgrade and Key Tokens
Note: FCM connection to system is temporarily disabled
during the installation of upgrade or key tokens.
1. Ensure system is inactive.
2. Remove access cover (BD).
F
. 29
IG
3. Insert and press token (BT) firmly into slot.
Note: There is no preferred orientation of token.
BL
BS
F
. 30
IG
32
BD
TI12334A
TI12320A
BM
BT
4. Press and hold the push button (BM) for three sec-
onds and then release. The red LED (BL) until the
software is uploaded. See F
5. Remove token (BT) when software has successfully
uploaded or key token is no longer required.
Note: Upgrade tokens can be removed once the soft-
ware has successfully uploaded. If key tokens are used
by your Graco Control Architecture based system they
must remain in the FCM for features or settings to be
enabled. Key tokens are not present on all Graco Con-
trol Architecture based systems.
6. Replace access cover (BD).
Connect Cables
Ensure all cables are connected to FCM connectors.
See FCM Cable Connections, page 14.
. 30.
IG
3A0238G
Advertisement
Table of Contents
