Table of Contents
Advertisement
Repair
6. Remove the four socket head cap screws (204) con-
necting the motor adapter plate (203) to the hydrau-
lic housing (206).
201
213
205
212
F
. 26
IG
7. Remove four hex head cap screws (244), accumula-
tor (242), and mounting plate (240) from the motor
(201).
NOTE: Do not lose the spider coupler (213).
8. Remove four socket head cap screws (205) and
motor (201) from the motor adapter plate (003)
9. Loosen the set screw from the motor coupler (202)
and remove the motor coupler.
Install Motor
See F
. 25 and F
. 26.
IG
IG
1. Install motor coupler (202) onto motor (201). Apply
thread sealant to threads of screw. Torque motor
coupler set screw to 15 ft-lb (20.3 N•m).
NOTE: The coupler (202) must be 1.67-1.68 in. from
the face of the motor.
201
+.00
1.68
-.01
30
2. Apply thread sealant to threads of four socket head
3. Use four hex head cap screws (244) to attach the
4. Install spider coupler (213) into motor coupler (202).
5. Apply thread sealant to threads of four socket head
202
203
NOTE: Be sure to align teeth of the pump coupler
206
(212) with the teeth of the motor coupler (202).
204
6. Connect the tube assembly (247) to the applicator
7. Install washers (238) onto hex head cap screws
8. Use two hex head cap screws (258) to connect the
9. Install Hydraulic Power Pack. See page 28.
202
cap screws (205). Use four screws (205) to attach
the motor adapter plate (203) to motor (201). Torque
to 90 ft-lb (122 N•m).
accumulator (242) and mounting plate (240) to
motor (201). Apply thread sealant to threads of
screw. Torque to 35 ft-lb (47 N•m).
cap screws (204). Use four screws (204) to attach
the hydraulic housing (206) to the motor adapter
plate (203). Torque to 35 ft-lb (47 N•m).
housing (206) and the accumulator (242). Torque to
1-1/2 flats past hand tight.
(239). Align tank gasket (236), hydraulic housing
(206), and tank (237). Install screws (239). Torque
to 15 ft-lb (20.3 N•m).
support bracket (257).
3A0238G
Advertisement
Table of Contents
