Replace Tank Gasket; Remove Motor - Graco 24D829 Instructions-Parts List Manual

Replace Tank Gasket

1. Remove Hydraulic Power Pack. See page 27.
2. Remove hex head cap screws (239) and washers
(238) securing hydraulic housing (206) to tank
(237). Carefully remove motor (201) and hydraulic
housing assembly from tank.
3. Remove tank gasket (236). If tank (237) is dam-
aged, replace tank.
4. Install thrust washers (038) onto hex head cap
screws (039). Apply pipe sealant 070408 to threads
of screws. Align tank gasket (036), hydraulic hous-
ing, and tank (020) then install screws. Torque to
15 ft-lb (20.3 N•m).
5. Perform Install Hydraulic Power Pack procedure,
see page 28.
NOTICE
Do not over-torque any item that threads into the
hydraulic tank (237). This will strip the threads and
require tank replacement.
F . 24
IG
3A0238G

Remove Motor

1. Shutdown the system. See Shutdown on page 21.
2. Remove Hydraulic Power Pack. See page 27.
3. Disconnect the tube assembly (15Y684) from the
accumulator (242).
242
247
239
257
238
F . 25
IG
4. Remove two hex head cap screws (258) connecting
206
the support bracket (257) to the hydraulic housing
(206).
5. Carefully remove motor assembly from tank.
236
237
238, 239
201
240
Repair
264
206
258
237
29