Connect Material Hoses To System - Graco 24D829 Instructions-Parts List Manual

Setup
Connect Material Hoses to
System
For System With Circulation
NOTICE
Avoid routing hoses in walkway areas to prevent
operators from tripping on hoses running between
system components. This also prevents fittings from
leaking.
1. Connect the A (red) and B (blue) supply hoses, from
hose kit (3), to the GMS material manifold. See F
9.
2. Connect the other end of the supply hoses to the
applicator. See the applicator manual for fluid inlet
identification.
GMS material
manifold
3
421
F . 9
IG
NOTE: The circulation hoses contain a 10 ft (3 m)
extension hose to reach the tank stands.
3. Connect the other end of the A (red) circulation
hose (421) to the fluid inlet fitting on the A (red) tank
stand. See F . 9 and F
IG
4. Connect the other end of the B (blue) circulation
hose (422) to the fluid inlet fitting on the B (blue)
tank stand.
18
A
B
422
. 10.
IG
fluid inlet
.
IG
fitting
F . 10: Tank Stand Connections
IG
5. Tighten each fitting.
For System Without Circulation
Avoid routing hoses in walkway areas to prevent
operators from tripping on hoses running between
system components. This also prevents fittings from
leaking.
1. Connect the A (red) and B (blue) supply hoses, from
hose kit (3), to the GMS material manifold. See F
9.
2. Connect the other end of the supply hoses to the
applicator. See the applicator manual for fluid inlet
identification.
3. Hand tighten each fitting.
4. Tighten each fittings 1-1/2 flats past hand tight.
r_257968_3a0238_1c
NOTICE
.
IG
3A0238G