Install Hydraulic Power Pack - Graco 24D829 Instructions-Parts List Manual

Repair
6. Remove the two bolts from (258) from the fluid
housing (206) and replace each with a 5/16-18
thread eye bolt. Install a third 5/16-18 eye-bolt as
indicated.
206 258
Install third eye-bolt here
F . 22
IG
7. Run a rope through the three eye-bolts and between
the motor and the accumulator. Secure to a hydrau-
lic lift.
8. Remove the four bolts (57) and washers (56) secur-
ing the tank to the stand.
56, 57
F . 23
IG
To prevent serious injury from the hydraulic power
pack falling, ensure that the hydraulic power pack is
secured to the hydraulic lift before removing from the
stand.
9. Lift the hydraulic power pack (55) and place on a
sturdy location capable of supporting up to 300 lbs
(136 kg).
28

Install Hydraulic Power Pack

If any debris falls into the hydraulic tank, the debris
must be removed or machine damage will result.
Do not over-torque any item that threads into the
hydraulic tank. This will strip the threads and require
258
tank replacement.
1. Run a rope through the three eye-bolts and between
the motor and the accumulator. Secure to a hydrau-
lic lift. See F
2. Lift the Hydraulic Power Pack and place onto the
base enclosure. See F
3. Align the holes with the tank then install finger-tight
the four bolts (57) and washers (56) securing the
tank to the stand. Torque to 10 ft-lb (13.5 N•m).
4. Remove rope and lift.
5. Remove eye-bolts. Install original bolts (258) into
fluid housing (206). See F
6. Connect all electrical cables to the motor, three
directional valves, temperature switch, and pressure
transducer.
55
7. Connect all hydraulic lines to applicator housing.
See F
8. Connect heat exchanger inlet hose (76) and fitting
to elbow fitting (249) on hydraulic housing (206).
56, 57
Connect heat exchanger outlet hose (77) and fitting
to elbow fitting (248). See F
NOTICE
NOTICE
. 22 on page 28.
IG
. 23.
IG
. 22 on page 28.
IG
. 20 on page 28.
IG
. 21 on page 28.
IG
3A0238G