Kobalt SC2502LW Manual page 33

Adjusting the cutting wheel 90° to sliding
table (Fig. 32, 33)
● Disconnect the saw from the power source.
● Loosen the bevel lock knob (PP) and make
sure the cutting wheel is in the maximum
vertical position. Tighten the bevel lock
knob (PP).
● Place a 90° framing square on the sliding
table surface.
● If the cutting wheel is not 90° to the
groove (2-Fig. 32), loosen the lock
nut (3) with a adjustable wrench and turn
the hex bolt (4) (located under the cutting
arm assembly as shown in Fig. 33) in or
out accordingly with a 3 mm hex key until
the wheel is flush with the framing square
while moving down the center of the groove.
Tighten the lock nut (3).
● Make sure that the cutting wheel does not
touch either side of the groove (2-Fig. 32) in
the sliding table by pushing the table past
the cutting wheel.
Adjusting the cutting wheel 45° to sliding
table (Fig. 34)
● Disconnect the saw from the power source.
● Loosen the bevel lock knob (PP) and move
the cutting wheel to the maximum bevel
position.
● Place the combination square to the sliding
table surface.
● If the cutting wheel is not 45° to the
groove (5), loosen the lock nut (6)
with a adjustable wrench and turn the
45° hex bolt (7) (located on top of the
cutting arm assembly as shown in
Fig. 34) in or out accordingly by using a
3 mm hex key until it is 45° to the sliding
table surface and tighten the bevel lock
knob (PP). Tighten the lock nut (6).
● Make sure that the cutting wheel does not
touch either side of the groove (5) in the
sliding table by pushing the table past the
cutting wheel.
33
BOTTOM VIEW
34
33
PP
4
7
6
PP
5
3