Do you have a question about the Next Generation of Tough Tools KT1015 and is the answer not in the manual?
Questions and answers
Vince
March 25, 2025
Adjusting knife ky 1015
1 comments:
Mr. Anderson
May 14, 2025
To adjust the Kobalt KT1015 riving knife:
1. Place the saw on its side. 2. Remove the dust bin to access the riving knife adjustment screws. 3. Loosen all five screws first. 4. Adjust the alignment using the three smaller screws. You must adjust one screw at a time while slightly lifting the riving knife to access the next screw. 5. Once aligned, tighten the two screws that secure the riving knife stem.
Use a #3 metric Allen wrench for proper fit.
This answer is automatically generated
Rich
May 10, 2025
Does this saw have a fuse? what about over heating issues?
My saw just quite while cutting a 2x4 on edge.
I turned it off and let it cool, but in will not start.
Related Manuals for Kobalt Next Generation of Tough Tools KT1015
Need help?
Do you have a question about the Next Generation of Tough Tools KT1015 and is the answer not in the manual?
Questions and answers
Adjusting knife ky 1015
To adjust the Kobalt KT1015 riving knife:
1. Place the saw on its side.
2. Remove the dust bin to access the riving knife adjustment screws.
3. Loosen all five screws first.
4. Adjust the alignment using the three smaller screws. You must adjust one screw at a time while slightly lifting the riving knife to access the next screw.
5. Once aligned, tighten the two screws that secure the riving knife stem.
Use a #3 metric Allen wrench for proper fit.
This answer is automatically generated
Does this saw have a fuse? what about over heating issues? My saw just quite while cutting a 2x4 on edge. I turned it off and let it cool, but in will not start.