USING THE RIP/ANGLE GUIDE (FIG. 37)
This guide can be placed on either side of the
cutting wheel.
●
Loosen the lock knob (1) to move the guide
along the front rail to the desired position and
tighten the lock knob (1).
●
Loosen the Rip/Angle guide adjust lock
knob (2) to turn the guide to the desired
angle along the arc slot (3) and then tighten
the Rip/Angle guide adjust lock knob (2).
NOTE: Please make sure the cutting wheel
will not make contact with this guide during the
cutting operation.
FILLING/CHANGING THE WATER RESERVOIR
(FIG. 38)
WARNING: When filling/draining water tray,
make sure wet tile saw is unplugged from
wall outlet.
To fill the reservoir with water
●
Make sure the drain plug (DD) on the water
tray is tight.
●
Fill the water tray (B) with clean water.
Ensure the water level is between "MAX" (1)
and "MIN" (2) fill lines. Do not overfill.
To change the reservoir water
●
Disconnect the saw from the power source.
●
Place a bucket under the drain plug (DD).
●
Remove the drain plug (DD) and empty
waste water into a bucket. Do not allow the
water to splash onto the ground or around
the saw.
●
Rinse the water reservoir thoroughly.
●
Discard the waste water in accordance with
local regulations.
●
Replace the drain plug (DD) and refill water
tray with clean water.
37
38
DD
2
36
2
3
1
1