Kobalt SC2502LW Manual page 27

INSTALLING AND REMOVING THE REAR
WATER CATCH TRAY (FIG. 19)
Installing the rear water catch tray
● Align four slots located on the rear left and
right ends of the water pan with the arms of
the rear water catch tray (F).
● Tilt the rear water catch tray (F) up slightly
and then insert it into the slots of the water
pan as shown in Fig. 19.
NOTE: Make sure that the rear water catch
tray (F) is correctly installed before use as
shown in Fig. 19-1.
● The small rear flap (II) is installed and folded
over the rear water catch tray at the factory,
and should be unfolded when in use.
Removing the rear water catch tray
● Tilt the rear water catch tray (F) up slightly
and then pull it out of the slots of the water
pan.
INSTALLING THE SIDE TABLE EXTENSION
(FIG. 20) - BAG X
● From the right side of the saw, align the
pins (1) on the side table extension (E) with
the holes of the sliding table (TT).
● Secure in place by turning the side table
extension lock knob (UU) clockwise.
INSTALLING THE SIDE WATER CATCH TRAY
(FIG. 21)
● From the right side of the saw, slide the
side water catch tray (G) into the three slots
located on the sliding table (TT).
19
20
21
27
F
II
Correct
Fig. 19-1
TT
1
UU
TT
G
Flush
1
E