Kobalt SC2502LW Manual page 24

INSTALLING THE SIDE SPLASH GUARD
(FIG. 14)
● Place the side splash guard (K) over the rear
guard.
● Insert the two holes on the outside of the side
splash guard over the two screws (1) located
on the side of the upper wheel guard (ZZ).
NOTE: It is not necessary to loosen or
remove the screws (1) on the wheel guard to
install the side splash guard.
● Loosen the wheel guard lock knob (YY) to
open the upper wheel guard (ZZ). Place the
hole on the inside of the side splash guard
and insert onto the screw (2).
14
YY
2
K
24
ZZ
K
1