Kobalt SC2502LW Manual page 20

INSTALLING THE CUTTING HEAD ASSEMBLY
AND TABLE FRAME TO WATER TRAY (FIG. 9)
- BAG X
● Carefully lift the cutting head assembly
and table frame over the water tray (B), as
shown.
NOTE: The cutting head assembly and table
frame are heavy and it is recommended to
be transported with the help of 2 people, to
safely move it.
● Tilt the frame and insert heavy duty tabs (1)
into the slot (2) on water tray (B) at the back
of the unit.
● Secure the frame in place with two water tray
lock knobs (JJ) at the front of the unit.
INSTALLING THE WATER PUMP (FIG. 10)
The water pump recirculates water from the
water tray to the cutting wheel.
● Place the filter (Z) in the water tray (B) as
shown.
● The water pump (L) is equipped with suction
feet to secure in place. Press down firmly
on the pump to attach the feet to the bottom
of the water tray (B), which is marked
"pump" (1).
● Connect the clear water tube (2) to the
barbed end of the 90° fitting (3).
NOTE: Make sure the tube is placed under
the sliding table frame before installing onto
the pump fitting.
● Secure the water pump power cord (4) and
clear water tube (2) by placing them into the
two cord clamps (5) on the left side of the
table frame and twisting the ends closed.
● Insert the water pump power cord plug (6)
into the power cord receptacle (GG) as
shown in Fig. 10. The water pump will start
when the tile saw is turned on.
NOTE: Do not use pump when not
submersed in water as it may damage the
pump. If the pump does not push water out
of the clear water tube onto the blade after
starting the saw, unplug the saw from the
electrical outlet, disconnect the clear water
tube from the pump. Submerse the pump in
water, reconnect the clear water tube to the
pump, plug the saw back into the electrical
outlet and start the saw to get the water
flowing through the tube to the blade.
9
2
JJ
10
4
2
B
GG
6
20
1
B
5
2
L
3
Z
1