Kobalt SC2502LW Manual page 17

Assembling the left and right outer tubes to
the inner leg assembly (Fig. 4) - BAG U
● Pull the rubber strip (1) off the locking
hook (2). This will expose the center hole on
the outer tube.
● Position the inner leg assembly (N) and left
outer tube (3) so that they resemble an "X".
● Attach the left outer tube (3) to the inner leg
assembly (N) using a hex bolt (aa), a spring
washer (jj), two small spacers (bb) and a
nut (cc), as shown.
● Tighten with the adjustable wrench (not
included) for the nut (cc) and the 13 mm
wrench (not included) for the hex bolt (aa).
NOTE: Do not overtighten, because doing so
will not allow the leg assembly to move.
● Repeat the above steps to assemble the
right outer tube to the inner leg assembly.
Assembling the left and right handles
(Fig. 5) - BAG U
NOTE: The handle with the tab should be
installed on the right.
● Attach the left handle (O) to the left outer
tube (1) and the center brace (M) using two
hex bolts (aa), four small spacers (bb) and
two nuts (cc), as shown.
● Tighten with the adjustable wrench (not
included) for the nut (cc) and the 13 mm
wrench (not included) for the hex bolt (aa).
NOTE: Do not overtighten, because doing so
will not allow the leg assembly to move.
● Repeat above steps for the right handle (P).
4
1
aa
3
5
aa
1
M
17
jj
2
N
bb
M
cc
O
aa
cc
bb
bb
O
cc
1
P