hergom CRAFTSBURY Installation, Use And Maintenance Instructions page 9

5.
If you deem necessary, replace the ceramic fibre cord.
Tear it out from its posi�on and clear the le�overs of
it. Place the new ceramic fibre cord with the
measurements before detailed.
6.
Place the glass on the joint in its posi�on on the door.
7.
Screw in the glass fastening cramps once again,
placing the corresponding ceramic fibres under them.
8.
Fit the door in its posi�on again, and a�er that, fit the
arch.
Cleaning ash.
The ashes will be cleared when the heater is cold. Use a
protec�ng glove when the ashes are hot. Be very careful
when you handle, store or throw away the ashes.
To remove the ashes from the hearth proceed in the
following way:
1.
Open the hearth door and remove the ashes with a
scraper and a shovel or another adequate tool.
2.
The ashes must be thrown away from the hearth into
a metal container with an appropriate herme�c top.
Do not introduce any other object or rubbish inside
the container. Cover the container with the top and
let the ashes cool down. Do not place the container
on combus�ble surfaces or vinyl floors, as the
container may be very hot.
3.
While you get rid of the ashes, place the closed ash
container on a non combus�ble floor or on the
ground outdoors, far from all combus�ble materials.
4.
If necessary clean the hearth.
The ashes must be kept in the closed container un�l the
embers are completely cold.
NEVER place the ashes in wooden or plas�c containers,
or in paper or plas�c bags, regardless of the �me
elapsed since the fire has been put out. The embers
inside the ash bed keep heat during a long �me once
they have been removed from the hearth.
Cast iron
The external cast iron parts are vitrified with majolica
enamel.
The enamels may be cleaned with a normal window
cleaning product. Generally all needed is to clean it with
a slightly damp cloth. (Do not wet the painted parts as
oxida�on will appear if it is not quickly dried.)
The enamel with which your Cra�sbury heater is
treated, while opera�ng, most specially in high
combus�on moments, may show changes in its texture
and colour, causing fine cracks that go back to their
natural state when the heater cools down.
This process occurs due to the different expansion
coefficients of the materials used in the elabora�on of
this special high quality enamel. Do not use damp cloths
to clean the painted parts.
The paint used is an an� caloric 600ºC one which is
specific for heaters. If you decide to repair your heater,
contact your supplier to purchase the special paint.
MAINTENANCE PRODUCTS
Industrias HERGÓM, S.L. places a range of products for
the preserva�on of your heater and chimney at your
disposal: heat resistant paint, refractory pu�y, glass
cleaning products.
9 of 24