hergom CRAFTSBURY Installation, Use And Maintenance Instructions page 4

1 - INTRODUCTION
IMPORTANT! All local regula�ons, including those that
refer to na�onal or European regula�ons, must be
applied when installing this device.
The way the Cra�sbury Stove is installed will decisively
affect safety issues and its correct opera�on.
It is important to install the fireplace correctly. For the
correct installa�on of the Cra�sbury stove and chimney,
we recommend the installa�on be performed by a
professional.
The Cra�sbury Stove provides heat by radia�on; directly
hea�ng walls, ceilings...
2 - PRESENTATION
The Cra�sbury wood burning heater has the following
main characteris�cs:
•
It is constructed in cast iron, with assembled parts,
sealed and screwed together.
•
Cast iron lined.
•
It is designed for use with firewood only.
•
A hearth that allows to burn wood logs of up to 40
cms. long.
•
Primary air regula�on valve.
•
Indirect system of primary air supply, that descends
down the inside plan of the glass (self cleaning)
towards the bo�om of the hearth. Supplied, as well,
with a primary air hole located in the low central of
the hearth to favour the ligh�ng.
•
Glass self-cleaning.
•
Hinged front door with glass.
•
Op�onal horizontal or ver�cal smoke exit Ø150
mm. (6")
•
Levelling screws.
•
It lets of its heat by radia�on, directly hea�ng the
walls, roofs, etc. .
•
Fully factory assembled, with top smoke flue.
•
Op�onal outside air connec�on.
•
Op�onal rear shield.
Primary air
valve
Levelling
screws
4 of 24
FIG. 1
Op�on of rear
smoke flue exit
included
FIG. 2
Rear shield
(Accessory:
9921073)
Outside air
connec�on
(Accessory:
FIG. 3
9921074)
Door
Handle