Download Print this page

hergom CRAFTSBURY Installation, Use And Maintenance Instructions

Advertisement

Quick Links

Wood stove
CRAFTSBURY
INSTALLATION, USE AND MAINTENANCE INSTRUCTIONS.
1 of 24

Advertisement

loading

Summary of Contents for hergom CRAFTSBURY

  • Page 1 Wood stove CRAFTSBURY INSTALLATION, USE AND MAINTENANCE INSTRUCTIONS. 1 of 24...
  • Page 2 2 of 24...
  • Page 3: Important Note

    We would like to thank you for choosing our Cra�sbury Stove, which represents, in technique and style, a significant improvement on typical wood stoves. Your new Stove is, perhaps, the most advanced solid fuel hea�ng system known today. Owning a HERGOM Stove displays an excep�onal sense of quality.
  • Page 4 1 - INTRODUCTION IMPORTANT! All local regula�ons, including those that refer to na�onal or European regula�ons, must be Door Handle applied when installing this device. The way the Cra�sbury Stove is installed will decisively affect safety issues and its correct opera�on. It is important to install the fireplace correctly.
  • Page 5: Using The Stove

    3 - USING THE STOVE 4 - LIGHTING UP AND USE It is essen�al that the first ligh�ng is carried out in a slow Once your stove has been installed and connected to the way. chimney, you are ready to light the fire. The cast iron must be warmed up: Excessive heat on a Although your stove is easy to use, the combus�on new heater may cause cracks in the iron or cause...
  • Page 6 • Note: When you open the door to load the wood or Once the heater is hot, but does not burn to the replace the logs in your heater, it is recommendable to touch, close the primary air by sliding the control to first open only a li�le, wait a few seconds and then a�er the limit inwardly, and let the fire completely go out.
  • Page 7: Cleaning And Maintenance

    HEATERS WITH ENAMEL MAJOLICA VERY 5 - CLEANING & MAINTENANCE IMPORTANT! Your heater is a device that is subjected to extreme In the case of stoves enamelled in Majolica, it is normal temperatures and to the corrosive effects of combus�on for slight fissures to appear in the glazing, providing the residual materials.
  • Page 8 If the glass o�en gets dirty, the combus�on temperature To clean the difficult par�cles, open the door, remove level is low; this indicates the risk of creosote forma�on. the arch placed under the top, pull the door upwards The flue system must be checked at the heater and detach it from the heater.
  • Page 9 Cast iron If you deem necessary, replace the ceramic fibre cord. Tear it out from its posi�on and clear the le�overs of The external cast iron parts are vitrified with majolica it. Place the new ceramic fibre cord with the enamel.
  • Page 10 • 6 - SAFETY Never use coal or fuels that are not recommended for the opera�on of this product. WARNING! • Periodically inspect the chimney and clean Gas/log/pellet units get hot when in use. whenever necessary. Also inspect the state of joints, glass, screws...
  • Page 11 7- DIMENSIONS 11 of 24...
  • Page 12 8 - TECH SPEC. Maximum power (kW) Average flue gas temperatures (°C) CO emissions (13% O2 Vol%) 0,10 Dust (13% O2 – mg/m3) NOx emissions (13% O2 – mg/m3) OGC emissions (13% O2 – mg/m3) Efficiency (%) 79,1 Accepts logs of the following length (mm) Smoke collar (Ø...
  • Page 13: Exploded View

    9 - EXPLODED VIEW 13 of 24...
  • Page 14 14 of 24...
  • Page 15 15 of 24...
  • Page 16 CRAFTSBURY HF CRAFTSBURY HF Nº PAINTED ENAMELED BROWN 9921053 9921053 9921054 9921075 3 (*) 99J38 99J38 4 (*) 99J14 99J14 9921055 9921055 9921056 9921056 9921057 9921076 9921058 9921058 9917366 9917366 9917376 9917376 9921059 9921059 9920208 9920208 9921060 9921077 9921061 9921143...
  • Page 17 We recommend using spare parts recommended by the manufacturer. INDUSTRIAS HERGÓM, S.L., rejects any liability derived from a faulty installa�on or incorrect use and reserves the right to alter its products without prior warning. Any liability due to manufacturing defects will be subject to the criteria and verifica�on of the company’s experts and will be limited to the repair or replacement of its products, excluding any construc�on work or damage the said repairs may cause.
  • Page 18 10 – BAFFLE AND INTERNAL PARTS DISASSEMBLY1 18 of 24...
  • Page 19 11 –INTERCHANGING THE TOP/BACK FLUE OUTLETS 1 19 of 24...
  • Page 20 12 – FITTING THE OUTDOOR AIR INTAKE ACCESSORY 20 of 24...
  • Page 21 13 – ATTACHING THE REAR ACCESSORY 21 of 24...
  • Page 22 22 of 24...
  • Page 23 23 of 24...
  • Page 24 INDUSTRIAS HERGOM S.L SOTO DE LA MARINA - CANTABRIA Apdo. de correos 208 SANTANDER Tel: 0034 942 587 000 E-mail: hergom@hergom.com www.hergom.com C07100AB194 Versión 3 ED: 01/2021 24 of 24...