Zones; Block Diagram - Zones Menu - Tech Controllers EU-L-8e User Manual

VIII. ZONES
1. BLOCK DIAGRAM – ZONES MENU
This submenu enables the user to configure operation parameters for particular zones. When the pre-set temperature value
in a zone is reached, L-8 controller labels the zone as sufficiently heated and the status remains unchanged until the
temperature drops below the pre-set temperature by hysteresis value. When the temperature in all the zones is sufficient,
the controller disables both the pump and the voltage-free contact.
ON
Type of sensor
Pre-set temperature
Schedule
User settings
Floor heating
Hysteresis
Calibration
Actuators
Window sensors
Heating
Cooling
Floor pump
Heating
Cooling
Weather-based control
Temperature settings
Registration
Operation mode
Registration
Actuator removal
Settings
Registration
Sensor removal
Settings
21