PROBLEM
Motor will not run.
Blades breaking.
Vibration (there is always
some vibration when the saw
is running).
Blade runout.
Page 25
TROUBLESHOOTING
PROBLEM CAUSE
• Problem with ON/OFF switch, power
cord, or outlet.
• Motor defective.
• Incorrect tension.
• Overworked (worn out) blade.
• Wrong blade being used.
• Twisting blade in wood.
• Improper mounting of saw.
• Mounting surface.
• Loose table or table resting against
motor.
• Loose motor mounting.
• Insuf cient blade tension.
• Dull blade causing excessive force to be
used at workpiece.
CORRECTIVE ACTION
• Have worn parts replaced before using
scroll saw again. Have the proper outlet
installed by a quali ed electrician.
• Do not attempt any repair. Have repaired
by a quali ed service technician.
• Adjust blade tension.
• Reduce feed rate or replace blade.
• Use narrow blades for thin wood, wider
blades for thicker wood.
• Avoid side pressure on blade.
• See proper mounting instructions.
• Replace plywood workbench surface
with solid lumber surface.
• Tighten table bevel lock knob.
• Tighten motor mount screws.
• Increase blade tension.
• Renew blade and correctly tension.