Table of Contents
Advertisement
DUST BLOWER ADJUSTEMT (Fig. 4)
The attached dust blower (A) is designed to direct air to the
cutting line. Adjust the dust blower to the desired position.
For the best results, always direct air ow at the blade and
the workpiece.
INSTALLING BATTERIES FOR LED LIGHT
(Fig. 5)
• Remove battery compartment cover (A).
• Install two AAA batteries (B) (not included) according to
polarity indicators inside the battery compartment.
• Replace the battery compartment cover (A).
CAUTION:
If the LED light will not be used for more
than three months, remove the batteries in order to avoid
damage from possible leakage.
LED LIGHT ADJUSTEMT (Fig. 6)
With an easy ON/OFF switch (A), the attached LED light (B)
keeps the cutting line on the workpiece lighted for more
accurate scroll cut. Adjust the LED light to the desired
position.
• To turn on the LED light, press the "
• To turn off the LED light, press the "OFF" button.
CAUTION:
Do not stare at operating lamp.
Page 13
ASSEMBLY
FIG. 4
FIG. 5
FIG. 6
" button.
B
A
A
B
A
Advertisement
Table of Contents
