Performax 240-3726 Operator's Manual page 15

SQUARING THE WORK TABLE TO THE
BLADE (Fig. 6a-6c)
• Loosen drop foot lock knob (A), move the drop foot
assembly(B) upward as far as possible.
• Loosen the bevel lock knob (C) to tilt the work table until
it is approximately perpendicular or at right angle to the
blade.
• Place a combination square (D) on the work table (E) next
to the saw blade (F).
• Loosen the screw (G) holding the bevel indicator (H). Move
indicator to the 0° mark and securely tighten screw.
Remember, the bevel scale (I) is a convenient guide but
should not be relied upon for precision. Make practice
cuts on scrap material to determine if your angle settings
are correct.
CAUTION:
Make practice cuts on scrap wood to
check if the bevel angle settings are correct before important
angle cuts.
ASSEMBLY
FIG. 6a
A
FIG. 6b
I
FIG. 6c
F
C
H
G
E
B
D
Page 14