Accessories; Change The Registration; Pre-Programmed Memory Locations - Johannus Vivaldi 15 User Manual

4.9

Accessories

4.10

Change the registration

The 0-piston cancels registration in two ways:
4.11

Pre-programmed memory locations

Pre-programmed memory locations are available by operating pistons PP
to T. These six memory locations have factory settings (presets)
appropriate for the quiet pianissimo to the loud tutti.
Calling up a pre-programmed memory location
1.
Programming a pre-programmed memory location
1. Select the desired stops.
2.
3. Press the desired pre-programmed memory location (PP-T).
4. Release the pre-programmed memory location piston (PP-T).
5. Release the SET piston.
Chorus (CH): Is a function for lightly detuning the organ stops to give it
a broader and livelier sound. Use the CH piston to activate the Chorus.
Fix Accessories (FA): This is a function for fixing accessories. As long
as this piston is active, the couplers and tremulants can only be
switched on and off manually.
Reeds Off (RO): This is a function to switch off all reeds
simultaneously. As long as this piston is pressed, no reeds can be
activated. When this function is switched off, the reeds that were on
are activated again. Use the RO piston to activate the Reeds Off
function.
General Crescendo pedal (CR): This is a function for switching the
General Crescendo pedal on and off. See § 4.14.
A short press on the 0-piston: Only the last change is cancelled.
A long press on the 0-piston: All registrations are cancelled.
Press a pre-programmed memory location (PP-T). The active stops
light up.
The current setting of the pre-programmed memory location will
be lost.
Programming the pre-programmed memory location is limited to
the text on the piston. For example, it is not advisable to program
a pianissimo registration under the tutti piston.
Press the SET piston. Hold in the piston.
18