Installing The Hotwire 6371 Radsl Router - Paradyne Hotwire 6371 Installation Instructions Manual

Installing the Hotwire 6371 RADSL Router

Place the Hotwire 6371 RADSL Router on a flat surface with clearance for the rear
connectors.
Procedure
1. Use the supplied RJ11 6-pin cable for the DSL connection. Insert one end of the
cable into the jack labeled DSL. Insert the other end into the wall jack labeled DSL.
DSL
Jack
If the Hotwire 6371 RADSL Router is installed on the same line as POTS, a
Hotwire 5038 Distributed POTS Splitter can be used as a phone filter. One 5038
Distributed POTS Splitter is installed as a phone filter for each telephone, as
shown below. To install the Hotwire 5038 Distributed POTS Splitter, refer to the
Hotwire 5038 Distributed POTS Splitter Customer Premises Installation
Instructions.
Distributed
POTS Splitter
Line from
RJ11 Wall Jack
Distributed
POTS Splitter
6371 RADSL Router
Customer Premises (CP)
Distributed
POTS Splitter
Line from
RJ11 Wall Jack
8
00-16509-01
Hotwire DSL
Router
00-16566-01