2. COMPONENT IDENTIFICATION
NOTE: Diagrams may vary according to the types.
Installation
1) Wheels
- Put the tool upside down.
- Add the axis on the tool.
- Then install a support on each side, and then fix the supports by screwing in the screw and
nut holes provided.
- Install a washer, the wheel and a nut on each side of the axle.
2) Feet
- Keep the tool upside down.
- Locate the two holes on the bar. Screw place the feet on each side then screw screws and
nuts to fix them.
3) Handles
- Put the tool in the normal position.
- On each side, locate two holes. This is the place to install the handles.
- Install the handles, then secure them with the screw and nut provided.
8