Table of Contents
Advertisement
Power-On
When power is applied, the ReachDSL modem performs self-diagnostics and the PWR
LED is on. The self-diagnostics includes a power-on self-test and all of the LEDs turn on
for one second.
ReachDSL
Status LEDs
All of the LEDs turn on and off during the power-on self-test. After a successful self-test,
the LEDs should appear as indicated in BOLD in the Condition column below.
LED
Condition Status
PWR
ON
ALM
OFF
ON
TST
OFF
ON
LINE
ON
OFF
TX/RX
ON
OFF
ETHERNET ON
OFF
Refer to
Troubleshooting
Power – green
Alarm – red
Test – yellow
PWR
ALM
TST
ReachDSL modem has power.
No active alarms.
An alarm condition exists.
No active tests.
The TST LED is on during the power-on self-test and
during a test initiated by the service provider.
The DSL link is active and ready to transmit and receive
data.
The DSL link has not been established.
Data transmission is in progress on the DSL line.
The modem is not transmitting or receiving data.
The Ethernet connection to the Ethernet hub or PC is
active.
No Ethernet 10BaseT device is detected.
on page 9 for LED indications requiring action.
DSL Line – green
Transmit/Receive – green
Ethernet Link – green
LINE
TX/RX
8
ETHERNET
01-17003
Hide quick links:
Advertisement
Table of Contents
