Table of Contents
Advertisement
Setup Checklist
Following are the steps necessary to install and set up the TV
Setup and Operation Checklist
1. Unpack the TV and all accessories.
2. Connect the TV to antenna and all external video source equipment.
See pages 10 - 18.
3. Install batteries in remote control.
See page 11.
4. Plug TV and source equipment into power outlets.
See page 11.
5. Turn TV on.
See pages 8, 9 or 20.
6. Choose on screen menu language.
See page 33. (English is default.)
Reception Setup and Channel Search
8. Use Auto Program* to search for all channels in your area.
See page 19.
7. Select viewing source for TV.
See page 22.
8. Adjust Installer menu per requirements of the lodge entertainment system.
See pages 41 through 49.
Customize the TVs Features for the End User
9. Fine-tune source image and sound to personal preference or as required by
source.
See pages 25 through 40.
Additional Features Setup
See page 5, Table of Contents.
*Auto Program finds channels which have a signal present and are actively being
broadcast. Some broadcasters do not provide or broadcast a signal continuously. As
a result, some DTV channels may not be found in the channel scan. If you know
that there is a DTV channel that was not found by Auto Program, run Auto
Program again; when the DTV channel is actually sending out a program signal.
Page 7
Advertisement
Table of Contents
Troubleshooting
