Vcr Setup; When Connecting With An Antenna; When Connecting With A Rca Cable - Zenith 42PC3DU Manual

- To avoid picture noise (interference), leave an adequate distance between the VCR and TV.
- Typically a frozen still picture from a VCR. If the 4:3 picture format is used; the fixed images on the sides
of the screen may remain visible on the screen.

When connecting with an antenna

SERVICE SERVICE
HDMI IN
2
1(DVI) 1(DVI)
ANTENNA/ ANTENNA/
CABLE IN CABLE IN
SERVICE
HDMI / DVI IN
ANTENNA/
CABLE IN

When connecting with a RCA cable

VCR
OUT
(R) AUDIO (L) VIDEO
IN
VIDEO AUDIO
1
OPTICAL
( )
DIGITAL AUDIO
AUDIO AUDIO
VIDEO VIDEO
S-VIDEO VIDEO AUDIO
OUT
OPTICAL PTICAL
( )
MONO
DIGITAL AUDIO
S-VIDEO S-VIDEO
VIDEO VIDEO AUDIO AUDIO
OUT OUT
• If you have a mono VCR, connect the audio cable from the VCR to the AUDIO L/MONO jack of the
set.
AUDIO
VIDEO
OPTICAL
( )
DIGITAL AUDIO
VIDEO AUDIO
S-VIDEO VIDEO AUDIO
OUT
2
VCR
ANT IN
S-VIDEO OUT
ANT OUT
(R) AUDIO (L) VIDEO
OUTPUT
SWITCH
3 4 IN
1
RGB IN
(PC) (PC)
AUDIO IN AUDIO IN REMOTE REMOTE
(RGB/DVI) (RGB/DVI) CONTROL IN CONTROL IN
RS-232C IN RS-232C IN
RGB IN
(CONTROL (CONTROL & SER & SERVICE) VICE)
(PC)
AUDIO IN REMOTE
(RGB/DVI)
CONTROL IN
RS-232C IN
(CONTROL & SERVICE)
ANT IN
S-VIDEO ANT OUT
OUTPUT
SWITCH
3 4

VCR Setup

Connect the RF antenna out socket of the VCR to
1
the Antenna socket on the set.
Connect the antenna cable to the RF antenna in
2
socket of the VCR.
Set VCR output switch to 3 or 4 and then tune TV
3
to the same channel number.
Insert a video tape into the VCR and press PLAY
4
on the VCR. (Refer to the VCR owner's manual.)
Connect the AUDIO/VIDEO jacks between TV
1
and VCR. Match the jack colors (Video = yellow,
Audio Left = white, and Audio Right = red)
Insert a video tape into the VCR and press PLAY
2
on the VCR. (Refer to the VCR owner's manual.)
3 Select AV1 input source using the INPUT button
on the remote control.
- If connected to AV IN2, select AV2 input source.
Installation
19