Connections/Installation Overview - Zenith Direct-View Concierge H27H38DT Installation Manual

Connections/Installation Overview

Rear Connections Panel
Use this page for reference when connecting analog or digital signal sources and other source equipment.
To hookup source equipment, refer to the next page; shows pages to go to for equipment hookup options.
Also, see the front connection panel hookup options on page 20.
Notes:
• Digital cable is not available on this TV.
• If only one wire provides the signal source, use a high-quality 2-way RF signal splitter and connect it to
both the Antenna-Cable and Digital Antenna RF jacks on the TV, see below.
Matrix Out
Connect external speaker
here.
Antenna/Cable
Connect analog off air
antenna or analog CATV
signal source here.
Digital Antenna
Connect if digital signal
source is available.
Note: If both digital and
analog signals are only
available from one RF
lead, connect a signal
splitter (not provided).
MPI Ports
Connect LT2000 clone
programmer to either
MPI port.
Note: Do not make con-
nections to both MPI
ports at the same time.
Digital Cable (DCATV)
This TV cannot be used for digital cable signals.
Page 10
Antenna
Digital
Cable
Antenna
M.P.I.
M.P.I.
Video In R-Audio-L
Connect composite
Video-Audio source here.
Ty pi ca l
TV B ac k
Video
R- Audio - L
In
In
S-Video
R- Audio - L
In
In
S-Video In R-Audio-L
Connect S-Video-Audio
source here.
Matrix
Out