Zenith Direct-View Concierge H27H38DT Installation Manual page 44

Installer Menu
Installer Menu Items 88-I through 103-I
Menu Function Value
Item Range
88-I. EN NOISE MUTE
89-I. POKE ENABLE
90-I. KEY LOCK
91-I. NOT USED
92-I. NOT USED
93-I. NOT USED
94-I. NOT USED
95-I. AUDIO MD DISP
96-I. NOT USED
97-I. NOT USED
98-I. NOT USED
99-I. NOT USED
100-I. ATSC TUNE MD
101-I. STRT MINOR CH 0 ~ 255
102-I. NOT USED
103-I. A RATIO LOCK
Detailed Descriptions of Installer
Menu Items
0-I. INSTALLER SEQUENCE
Gives access to Installer Menu depending on the
code selected.
0 = 9876 1 = 4321
2 = 1478 3 = 3698
1-I. POWER MANAGE (Power Management)
Determines hours of no activity before automatic
shutoff. The POWER MANAGE function is for saving
energy. When set to 0, Power Manage is OFF.
Settings range from 0 - 7, with 1 - 7 representing
the hours that the TV will remain on, unless there
has been activity from either the control panel or
remote control.
*M.P.I. Multiple Protocol Input: ZENITH protocol
for remote control of TV through RJ11 (M.P.I.) jack
on TV connections panel.
Page 44
Default Brief Description of Function and Comments
Value
0 / 1 1 When set to 1, the audio signal volume is limited to
a minimum value if no signal is being received from
0 / 1 0 When set to 1, writing to Non - volatile memory
0 / 1 0 When set to 1, front keyboard functionality is disabled.
0 / 1 1 When set to 1, Audio Mode Information is enabled to
0 / 1 0 Sets ATSC tuning mode. Set to 0 for virtual channel,
0 Sets the starting minor channel. For NTSC set to 0.
If not 0, sets minor channel number. Set to 255 to
0 / 1 0 Set to 1, to retain current aspect ratio at turn Off.
At turn On, last set aspect ratio will be used. Set to 0 to
reset picture aspect ratio to default at TV turn On.
2-I. AC ON (AC Power Switchable)
Allows the TV to turn ON just by applying AC
power. Pressing the POWER button is not neces-
sary. This is desirable when the TV is plugged into
a cable box or a power outlet controlled by a wall
switch. Use ADJ to select 0 or 1, where 0 is the
default is OFF, and 1 is ON.
Note: When set to 1 (ON), the TV does not
respond to ON/OFF commands from either the
remote or the control panel, and the SLEEP TIMER
is also not functional.
3-I. BAND/AFC (Band/Automatic Frequency
Control)
There are 8 possible settings for this option:
0 = Broadcast Fixed
5 = CATV Fixed
6 = HRC Fixed
7 = ICC Fixed
Channels are accessed faster when fixed modes are
used. The AFC (search modes) should only be used
the broadcaster.
through *M.P.I. is enabled.
appear in the Channel Time Display.
set to 1 for physical channel.
show last tuned channel at turn On.
4 = Broadcast AFC
1 = CATV AFC
2 = HRC AFC
3 = ICC AFC