Table of Contents
Advertisement
Troubleshooting
After re-starting (Key Off → Key On) the vehicle,
indicator will resume normal operation. Clicking the
button when the indicator is flashing in red will stop the
flashing. For the sake of your safety, please go to a
KYMCO dealer for check-up.
Dashboard Level Indication:
a. On activation of heating function, Dashboard will
receive signal from controller and display the current
heating level to the user.
b. Level Indication:
• Level 1: 45℃
• Level 2: 55℃
• Level 3: 65℃
• Heating Function OFF: All goes off.
(This is only the setting value; the actual temperature
depends on the environment temperature and vehicle
Control Functions of Mechanism
condition, a difference may exist.)
c.If the signal from the controller to the dashboard is
faulty for any cause, a
Dashboard.
Please do not use the heating function for extended
•
time if the vehicle is not under ignition state, this will
result in early depletion of the vehicle battery.
When restarting the vehicle, the handlebar heating
•
function will be reset to off state.
2. Set/decelerate button (-)
3. Reset/accelerate button (+)
4. Cruise control setting button:
The vehicle speed must be greater than 45km/h to set
the setting.
The steps are as follows:
4-1.Press cruise control button ON
4-2.Start the setting after the indicator is lighted.
4-3.Accelerate to the desired cruise range.
4-4.Press "SET" key.
39
symbol flashes in the
Warning
4
3
Advertisement
Table of Contents
