Cleaning Battery Poles
For cleaning battery poles, remove a battery fixing screw
first.
If battery pole is corroded, remove the battery for
cleaning.
After cleaning, apply a thin layer of grease or Vaseline on
battery poles before installing battery.
Keep away from naked fire when removing/installing a
•
battery.
For removal, turn KEYLESS Main Switch to OFF
•
position first. Followed by removing the negative (-)
wire, then the positive (+) wire. Connect the positive
wire first when installing, then the negative.
Fully tight a slackened nut of battery poles.
•
Caution
Simplified Maintenance and Repair
Precautions on using batteries:
Electrolyte in the battery contains sulfuric acid,
•
therefore is toxic and dangerous; severe burn may
occur on negligence; avoid getting in contact with skin,
eye or clothing. Wear goggles when working in the
vicinity of battery. In the event of following conditions,
take first aid measures as required:
Skin contact: Rinse with plenty amount of clean water.
•
Ingestion: Drink large amount of water or milk and
•
seek medical care immediately.
Eye contact: Rinse with clean water for 15 minutes
•
and seek medical care immediately.
Battery will generate explosive hydrogen, therefore
•
shall be kept away from any fire source (e.g. spark,
flame or lit cigarette).
Provide with sufficient ventilation if charged in an
•
enclosed room.
Store batteries in a location where children cannot
•
access.
The battery is located under the front cover. Remove
•
the rear seat cushion and remove the seat cushion
cover, and the battery will be exposed. For re-charging
the battery: When battery power is about to deplete,
immediately go to a KYMCO dealer for re-charge.
Keep in mind that the more option devices installed on
the vehicle, the faster the battery power depletes.
89
7
3