Advertisement
–
Remove screws
–
Move the handlebar support in the desired position and mount
and tighten screws
Guideline
Screw, handle-
bar support
Info
Position the handlebar support so that it is even.
W00324-11
Warning
Danger of accidents A repaired handlebar poses a
safety risk.
If the handlebar is bent or straightened, the mate-
rial becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged
or bent.
W00384-10
–
Position the handlebar.
Info
Make sure the cables and wiring are routed correctly.
–
Position the handlebar clamps. Mount and tighten the screws
evenly.
Guideline
Screw, handlebar
clamp
Info
The markings on the handlebar should be at the center
of the handlebar clamps.
Keep the installed gap widths equal when tightening.
3
and take off the handlebar support.
3
.
M10
40 Nm (29.5 lbf ft)
M8
20 Nm (14.8 lbf ft)
SETUP 2
Loctite
®
243™
5
Advertisement
